Leave Your Message
Achieving Multi-Cylinder Precision: A Sourcing and Selection Guide for Hydraulic Synchronous Motors
Company News
News Categories
Featured News

Achieving Multi-Cylinder Precision: A Sourcing and Selection Guide for Hydraulic Synchronous Motors

2026-06-29

In hydraulic systems utilizing multiple cylinders or motors—such as lifting platforms, large gantry cranes, or synchronized industrial presses—ensuring that all actuators move at the exact same speed is a notorious engineering hurdle. Because hydraulic fluid naturally follows the path of least resistance, uneven mechanical loads cause unequal cylinder speeds. A Hydraulic Synchronous Motor (also known as a rotary gear flow divider) solves this problem mechanically.

A synchronous motor consists of multiple coupled gear sections within a single housing. As fluid enters the inlet, it forces the interconnected gears to rotate at identical speeds, thereby dividing the single input flow into multiple equal (或 proportional) output flows, independent of the external working pressures on each individual cylinder.

Critical Factors for Proper Selection:
Number of Sections & Flow per Section: Calculate the exact displacement required per cylinder cycle to match the specific displacement per section of the flow divider.
Pressure Differential (Δp): Ensure the synchronous motor's pressure rating can handle the maximum potential pressure variance between the lightest and heaviest loaded cylinders in your loop.
Integration of Relief Valves: Always opt for synchronous units equipped with integral phase-correction (end-stroke relief) valves. This allows the cylinders to automatically re-synchronize and bleed trapped air at the end of every stroke, preventing structural distortion over long-term operation.

By properly sizing your hydraulic synchronous motor based on maximum flow variance and system pressure, you can eliminate the need for complex, high-cost electronic proportional valve networks while achieving rigid, dependable synchronization.